The instant glue Notes and the basic characteristics of
Time：2012-10-12 15:13:55 Hits：1990
The main ingredients of instant glue α-cyanoacrylate glue, it is a one component, low viscosity, transparent, room temperature fast curing adhesive. Also known as cyanoacrylate. Wide adhesive surface of the vast majority of the material has a good bonding capacity, room temperature curing one of the types of plastic.
Basic characteristics
1. Curing speed, high bonding strength, easy to operate, convenient, versatile, good aging resistance, suitable material bonded to a small area (5 x 5 cm)
2. The room temperature curing, indoor, outdoor, may, without other curing auxiliary device (preferably in the operating environment of better ventilation of air convection, can avoid the whitening phenomenon)
3. Applicable temperature of -50 to +80 degrees (instant can withstand temperatures up to 100 degrees) In addition to the special high temperature glue for temperatures up to 120 degrees
4. Applicable to the general environment, should not be in the long-term contact with water, soaked in water, strong acid and alkali place (including alcohol, C adit)
Placed in a cool place away from direct sunlight (in order to extend the storage time available refrigerator refrigerated.)
Usage
1. Surface treatment: use dry cotton cloth or sandpaper will then remove surface dust, oil, rust, and then cleaning agents wipe with acetone or trichlorethylene then to clean the surface
2. glue:
1), use a dry cotton cloth or sandpaper will then remove surface dust, oil, rust, and then cleaning agents wipe with acetone or trichlorethylene, then clean the surface.
2), unscrew the front cover, you can use the bottle if any glue first with cotton cloth glue wipe clean, then put needles or PE dropper after use, to be to control glue traffic to ensure that the effect of bonding.
3), is followed by the surface of a small drop of adhesive, instantly be bonded and maintained until hardening until seconds ranging hardening time. PP special glue for about 30 minutes to reach the practical strength, the maximum strength can be obtained after 24 hours.
3. Use after cleaning up the bottle, and the lid is tightened.
4. set the glue after use and stored in a cool dry place.
Precautions
1. Do not wear knit gloves use, cyanoacrylate gloves woven material absorption polymerization occurs rapidly reaction generated when high-calorie, will burn your hands, so please do remember, do not wear knit gloves use.
2. If the eyes do not accidentally come into contact with the cured glue hard will hurt the eye, do not rub their hands and rinse immediately with plenty of water or with warm towels, hot packs, eyelids sweating naturally separated, and not forcibly pull seriously, and hospital emergency treatment; contact with skin, soak in warm soapy water, acetone, glue solution to remove.
3. Cyanoacrylate volatile irritant, in the large-scale use in the workplace should be kept ventilated.
4. When substantial leakage water cured and then scrape.
